About this product
1. Service conditions: altitude no more than 1000 M
2. Ambient temperature: -20°C - 50°C
3. Relative humidity: 45% - 95%
4. Voltage range: AC 200v - 245v
5. Heating head temperature: 260 ± 5°C
6. Safety index: insulation resistance is not less than 1mΩ
7. Leakage current: ≤ 5 mA (AC RMS)
This product is suitable for the connection of thermoplastic pipes such as PP-R /
PE / pp-c. This product has accurate temperature control, high reliability, High
security and unique non adhesive mold technology, which is convenient for
customers to operate.
1. Main technical indicators
1. Service conditions: altitude no more than 1000M
Ambient temperature: - 20°C-50°C
Relative humidity: 45% - 95%
Voltage range: AC 200v-245v
50±1Hz
2. Heating head temperature: 260 ± 5C
3. Safety index: insulation resistance is not less than 1m Ω
Leakage current: ≤ 5mA (AC RMS)
2. How to use it
1. Fix the welding machine and install the heating head, place the welding
connector on the rack, install the corresponding heating die head according to
the required pipe specification, and tighten it with the inner hexagon. Generally,
the small one is at the front end, and the large one is at the rear end.
3. Power on
Turn on the power supply (note that the power supply must be equipped with
grounding protection wire), the green indicator light is on, and when the green
indicator light is off, the red indicator light is on, indicating that the welding
machine is in the automatic temperature control state and can start operation.
Note: in the automatic temperature control state, the red light and green light will
turn on alternately, which indicates that the welding machine is in the controlled
state and does not affect the operation.
4. Welded pipe
Use the pipe cutter to cut the pipe vertically, push the pipe and pipe fitting into
the die head of the machine without rotation at the same time, and operate
according to the requirements in the table below. After the heating time is
reached, take off the pipe and pipe fittings from the die head immediately and
insert them into the required depth in a straight line without rotation, so as to
make the flange uniform at the joint.
Note: if the operating environment temperature is lower than 5°C, the heating
time should be extended by 50%.
5.Notice
1. This product adopts single-phase three pole safety flat plug, and users are not
allowed to change it
Plug, the plug must be inserted into the socket with ground lead.
2. When using it,, hands and inflammables shall not touch the heating plate
as to avoid accidents.
3. Don' t take it apart unless you' re professional. Open it may
cause electric shock and ruin the performance of the machine.
performance
4. If the red and green indicator lights do not change for a long time, it means
the machine is break down, stop working and cut off the power immediately.
5. This welding machine is guaranteed for twelve months from the date of
purchase.(Except for box and artificial damage).
6. The temperature of the welding machine has been adjusted before delivery,
and non professionals are not allowed to change it, as not to affect the normal
use and service life of the welding machine.
Ambient Temperature | -20°C - 50°C |
Relative Humidity | 45% - 95% |
Voltage Range | AC 200v - 245v |
Heating Head Temperature | 260 ± 5°C |
Leakage Current | ≤ 5mA (AC RMS) |