Note：

1. P=V*1

2. Measuring standard target: 15.5 * 8 * 5t(Anisotropic Plastic Magnet)

3. Sin Wave / X, Y, Z 3 Directions /3 Times Each Direction / 11mS Each Time.

4. Double Amplitude 1.5mm / 10Hz~55Hz~10Hz(Sweep 1min) / X, Y, Z 3 Directions / 1Hour Each Time.

How to Mount 

Step 1: Loosen screw and nut. 

Step 2: Place the sensor and wrap the band around the cylinder.

             Position the hook with the nearest hole on the band and mark the hole.

Step 3: Remove mounting assembly and cut the band at the nearest edge of next hole.

Step 4: Wrap the band and put the hole on the hook.

             Position the switch and tighten. Adjust the screw to fasten but do not over-tighten as it may damage the switch.