1.The machine can press the powder material into tablet.

2. It could be used in pharmaceutical factory,chemical factory, hospital, R&D institution, laboratory.

3. This machine is with good performance, strong suitability, simple operation, easily repairs, small cubage and light.

4. Under the conditions or power cut, hand swing available.

5. The depth of filling and the thickness of tablets is adjustable.

6. It is only with one set of die. (If you want to other kinds of dies, contact the customer serves )

Operation manual

1. Tablet Press Machine should be installed on the wood workable (as well on the cement table). Use three units of M12 boltsfor fixing it. The height between the workable surface and ground is around 600mm (consider easily to the operation). To be convenient to disassembled and repair, there should be a hole on the wood workable that its diameter around 35mm counter to the position of lower punch.

2. To insure the safety connecting ground wire before connecting the power, and then remove the triangle belt, connect the power of the machine and switch it on to observe the roiling direction of the operation. (The rotary direction of motor shaft should be on the same direction of the arrow of large pulley wheel). If the rotary direction is incorrect, you should connect another line, and then install the triangle belt.