1. The lightest tablet press machine, only hand-operate.

2. Used for pressing different kinds of granular raw materials into round tablets.

3. Only one pair of punching die can be erected on this press.

4. Both filling depth of material and thickness of tablet are adjustable.

5. Could change the mold,so you get the different tablet.

6. We could customize the punch as your demand.

7. Do not use the wet materials in order to avoid destroying machine.

Operation adjustment

Installation of punch die
Firstly, disassemble the hopper, feeder and the middle die , wipe up the table board die hole and the punch die to be assembled, and assemble them as per the following steps:
a)  Installation method of the round punch die:
Firstly, insert the lower punch to the hole of the lower punch core, pay attention that while inserting it to the indentation of the bottom punch, align to the fixing screw, and tighten the screw.
Insert the upper punch to the hole of the upper punch core, must insert it to the end, and use a spanner to tighten the screw. Put the middle die into the die hole, pay attention that the end surface of the middle die is on the same level with the plate surface, and after adjust it, tighten the screws.
Mount the middle die table plate on the machine body and screw the bolt. Rotate the flywheel by hand to make the upper punch drop slowly and insert into the middle die hole. Then adjust the middle die plate. When the upper punch inserted into the middle die hole is movable without collision, it is qualified. Then tighten the bolt of the middle die plate and rotate the flywheel 10 times until no hard rubbing is found, finally install the hopper and the feeder.
b)  Installation procedures of the flat punch die:
Note:Insert the upper punch of the flat die into the upper punch core, reaching to the bottom. Screw the nut but not too tight, and the upper punch can move. Then adjust the upper punch core and the hexagonal nut to reach the proper height (depending on the thickness of a tablet). Then turn the flywheel and align the upper punch with the middle die, drop slowly to insert into the middle die. Screw the nut and then turn the flywheel for over 10 times until no hard rubbing is seen.