1.Safty and environment friendly:Fast cutting and grinding,no break off,no pollution
2.High efficiency:Improving efficiency of 30%-50% than traditional cutting disc
3.Long service life:Using brazing technology,diamond on the surface not falling down,40-70 times longer than traditional resin tools.
4.Maintain machining accuracy: the contour shape of the alloy tool is basically not lost during use, and the outer diameter does not change
5.Wide application range: Suitable for a variety of processing materials, such as cast iron, section steel, stone, composite materials, etc.
Our super-hard alloy tools are produced by brazing. Under certain conditions, a layer of diamond is firmly welded to the metal substrate after a metal solder melting process. This type of product has the characteristics of high grinding efficiency, long service life, safety, environmental protection and pollution-free. Mainly replace the current resin bond corundum cutting and polishing tools, all coarse and medium coarse-grained electroplated diamond tools, and some hot-pressed sintered diamond tools
TAA alloy grinding wheel is widely used for cutting and grinding of ductile cast iron, Gray cast iron, cast steel, metal extrudate, reinforced concrete, fiber glass and refractory material.The main applicable industries include: foundry, machinery, ship building and repairing,construction, composite processing, automobile disassembling, emergency rescue, and so on.
Comparison with oridinary resin grinding disc：
Some pictures on site:
Wheel Type | FW100-07W |
Wheel Diameter | 4" (100 mm) |
Arbor Hole Size | 5/8" (16 mm) |
Thickness | 31/32"（2.5mm） |
Abrasive Material | Diamond |
Safety Rotary Speed(r/min) | 12000 |
Batteries Included? | No |
Batteries Included? | No |
Pieces / Package | 1 |
Weight / Package | 0.44pounds |
Package Size (Inch) | 4-1/4" x 4-1/4" x 2/16" 107 x 107x 3mm |
⚠ Before starting the equipment, make sure that the tools are installed firmly, start idling for a few minutes, check whether the equipment is vibrating, and observe whether there is any slip, swing or jump,then start it.
⚠Always Wear protective shields, gloves, earplugs, etc. During operation.
⚠Cut into the workpiece abnormally isnot allowed. During cutting, To apply side pressure or curve cutting to the saw blade isnot allowed. The knife should be stable to avoid the impact of the knife edge contacting the workpiece. When there is abnormal noise, severe vibration or odor, Shutdown for inspection.
⚠Check the wear of superhard tools regularly. When the cutting edge is severely worn and not sharp enough, cracks and deformations occur, stop the operation immediately.